The Peptide Report dosage guide

Thymagen Dosage Guide and Calculator

Thymagen research vial
Example vial shown

Thymagen dosage chart and reported amounts

The research protocol people follow is 100 to 200 mcg of Thymagen a day by subcutaneous injection for 5 to 10 days, then a break. With a 20 mg vial mixed with 3 mL of water, 200 mcg is 3 units on a U-100 syringe. People repeat the course one to four times a year rather than running it continuously.

The amounts in this chart come from online communities. The vial label shows the total peptide in milligrams (mg). The Amount column shows a portion of that total in micrograms (mcg). The syringe mark shows how much liquid corresponds to that amount.

Syringe marks below are based on a 20 mg vial with 3 mL of water added. Change vial size or water in the calculator

ReportedAmountVolumeSyringe mark (U-100)Draws per vial
20 mg
mg
mL
Draw to this line
units on a U-100 syringe

Show me the math
1

Convert your vial to mcg, because 1 mg is the same as 1,000 mcg.

2

Divide by your water to see how much is in 1 mL.

3

Find what one unit holds. A U-100 syringe has 100 units in 1 mL.

4

Divide your amount by what one unit holds.

How people take Thymagen

Short course, not a cycle
This is the part people get wrong. These are run as a short course, not as a 12-week cycle. The protocol is 5 to 10 days and then you stop.
How often you repeat it
One to four times a year. The idea is cumulative: you run the course, you stop, you let the tissue respond, and you come back later.
How often within a course
Once a day, by subcutaneous injection, for the length of the course.
Where the numbers disagree
Thymagen is dosed far lower than most of its family, 100 to 200 mcg a day rather than 1 to 2 mg, and for a shorter course, 5 to 10 days. That is roughly a tenth of the generic bioregulator amount. If you apply the family default to this one you are off by a factor of ten. And because the identity question above is unresolved, even that figure is reported rather than established. A 20 mg vial at 200 mcg a day holds a hundred doses, which is many courses worth, so plan your mixing around that.

How to mix a Thymagen vial

Follow one step at a time. The steps use the water amount from your calculator.

  1. Step 1: Check the label

    Find the mg printed on your vial and enter it in the calculator. Let a frozen vial reach room temperature first.

  2. Step 2: Wipe both stoppers

    Clean the top of the peptide vial and the water vial with an alcohol swab. Let them dry.

  3. Step 3: Measure 3 mL

    Draw bacteriostatic water with a sterile syringe.

  4. Step 4: Add it slowly

    Let the water run down the inside wall of the vial. This helps prevent foaming.

  5. Step 5: Swirl gently

    Roll the vial until the powder fully dissolves. Do not shake it hard.

  6. Step 6: Label and chill

    Write today's date on the vial and refrigerate it at 2–8 °C (35.6–46.4 °F), away from light.

What you need

A vial of powder, a vial of water, a 3 mL syringe, an insulin syringe, and alcohol swabs
  • Peptide vial
  • Bacteriostatic water
  • 3 mL syringe for adding water
  • U-100 insulin syringe for measuring
  • Alcohol swabs

Plan your supplies

Pick how many weeks you will run it and how many shots you take each week. The list below shows everything you need.

12weeks
Shots per week

Storage and warning signs

Powder vials

Store at −20 °C (−4 °F) in dry, dark conditions and keep them in the original packaging.

Mixed vials

Keep them refrigerated and away from light. How long a mixed vial lasts depends on the product, so check its stability data.

Stop using a vial if

  • The liquid turns cloudy.
  • You can see particles.
  • The seal is damaged.
  • You do not know its storage history.

Product info and what Thymagen is

Thymagen is listed as a two amino acid peptide, Glu-Trp, written EW. It is aimed at the thymus and at T cell function.

There is a naming question here that matters more than usual. Glu-Trp is the sequence published for Thymogen, with an o. Thymagen may be the same peptide under a different spelling, or it may be something else. A name on a label does not establish what is in the vial, and it does not make amounts interchangeable with a peptide that shares part of its name. Bioregulators come out of a different research tradition from most of the peptides on this site. The protocols are short courses repeated a few times a year rather than long continuous cycles, and most of the published work is Russian. That is worth knowing before you compare one with something like BPC-157, which is run very differently.

Type
Russian bioregulator dipeptide
Sequence
Glu-Trp (EW)
Associated tissue
The thymus and t cell function
Common research vial
20 mg
Common water amount
3 mL, which makes 6.67 mg per mL
Amounts reported
100 to 200 mcg a day
Course length
5 to 10 days
Repeat
One to four times a year

What people use Thymagen for

T cell function

This is the narrower claim, and the one the dipeptide is associated with.

Age-related immune decline

The thymus shrinks with age, and that is the framing the whole thymic end of this family sits in.

A short course model

This one runs shorter than most of the family, 5 to 10 days.

How fast people notice it

The cumulative model means this is not a peptide where you watch the first week. The protocol is built around repeating a short course over months.

What the research shows on Thymagen

The standard protocol

The protocol carried in the Russian literature for this family is a short daily course by subcutaneous injection, 5 to 10 days per cycle, followed by a real break before the next one. For this peptide the reported amount is 100 to 200 mcg a day.

The identity question first

Glu-Trp is the sequence a 2016 Khavinson paper gives for Thymogen. Vendor listings treat Thymagen as a separate product. Until your certificate of analysis says which molecule you have, that is the first thing to settle, ahead of any dosing question.

Where it sits in the family

Glu-Trp is the dipeptide associated with the thymus, alongside Vilon (Lys-Glu). Both are described as working on T cell maturation.

How much is actually published

Less than for most of the group. Of the two large protocol reference sites, neither has a page for it. The research described for it is class-level, about short peptides generally, rather than about this molecule.

Where the evidence comes from

Most of the published work on this family comes from Vladimir Khavinson's group at the St Petersburg Institute of Bioregulation and Gerontology, or from researchers tied to it. There are no independent Western controlled trials.

The mechanism is a proposal, not a finding

These peptides are usually described as binding DNA directly and switching tissue-specific genes on. That idea comes from the same group that developed them. It is a hypothesis, and it is not how mainstream molecular biology explains how short peptides work. Anyone telling you the mechanism is settled is overselling it.

Where to buy Thymagen

Laboratory research supplier

BioEdge Research Labs

Quality varies a lot between sellers. I have been around research peptides for 10 years, and BioEdge is the supplier I send my readers to. Here is why.

The Peptide Report has a business relationship with BioEdge Research Labs. BioEdge sells this product for laboratory research only. BioEdge shipping policy

Want to learn to do the math yourself? Open the practice tools ▾

Learn to work out any vial

Pick a tool and try it. Each one uses the numbers from your calculator.

Now try one yourself

Use the same four steps. Once you can solve these, you can work out the units for any vial you ever pick up.

Your score: 0 correct.

units

Learn to read the syringe

Each line on the syringe is a unit of liquid. A unit measures volume, so the amount of peptide in it depends on your mix.

Tap the syringe or move the slider. The numbers use the vial you entered above. Read the line at the top edge of the plunger.

10units
0.10mL
mcg in your mix

See what water changes

More water makes the mix weaker, so the same amount takes up more units. The amount of peptide in the vial stays the same.

A draw under 5 units is harder to read accurately. Tap a row to use that water amount.

Thymagen questions and answers

What is the Thymagen dosage?

The reported protocol is 100 to 200 mcg a day by subcutaneous injection for 5 to 10 days, then a break before repeating one to four times a year.

How many units is 200 mcg of Thymagen?

With a 20 mg vial and 3 mL of water, 200 mcg is 3 units on a U-100 syringe and 100 mcg is 1.5 units. Use the calculator if your mix is different.

How long is a Thymagen course?

5 to 10 days. This is not a 12-week cycle.

How often can I repeat it?

One to four times a year is what the protocol describes. The model is cumulative rather than continuous.

How good is the evidence here?

Thinner than the numbers make it look. Almost all of it comes from one research group, most of it is in Russian, and there are no independent controlled human trials.

How much water goes in a 20 mg vial?

3 mL is the usual choice, which makes 6.67 mg per mL and puts 200 mcg at 3 units.

Why don't my units match another chart?

Most charts assume one vial size and one water amount. If your mix is different, every unit number changes, so run your own numbers.

This guide is for educational purposes only and is not medical advice. For research use only. Not for human or animal use. Reported amounts come from online sources and are not clinically validated. Consult a qualified healthcare professional for medical decisions.

Instant e-Book Download

Get Your Free Copy of The Ultimate Peptide Blueprint
Exact stacks, dosages & cutting-edge protocols to cut fat, build muscle, and keep results-no fluff.