The Peptide Report dosage guide

Prostamax Dosage Guide and Calculator

Prostamax research vial
Example vial shown

Prostamax dosage chart and reported amounts

The research protocol people follow is 500 to 1 mg of Prostamax a day by subcutaneous injection for 10 to 20 days, then a break. With a 20 mg vial mixed with 2 mL of water, 1 mg is 10 units on a U-100 syringe. People repeat the course two to three times a year rather than running it continuously.

The amounts in this chart come from online communities. The vial label shows the total peptide in milligrams (mg). The Amount column shows a portion of that total in micrograms (mcg). The syringe mark shows how much liquid corresponds to that amount.

Syringe marks below are based on a 20 mg vial with 2 mL of water added. Change vial size or water in the calculator

ReportedAmountVolumeSyringe mark (U-100)Draws per vial
20 mg
mg
mL
Draw to this line
units on a U-100 syringe

Show me the math
1

Convert your vial to mcg, because 1 mg is the same as 1,000 mcg.

2

Divide by your water to see how much is in 1 mL.

3

Find what one unit holds. A U-100 syringe has 100 units in 1 mL.

4

Divide your amount by what one unit holds.

How people take Prostamax

Short course, not a cycle
This is the part people get wrong. These are run as a short course, not as a 12-week cycle. The protocol is 10 to 20 days and then you stop.
How often you repeat it
Two to three times a year. The idea is cumulative: you run the course, you stop, you let the tissue respond, and you come back later.
How often within a course
Once a day, by subcutaneous injection, for the length of the course.
Where the numbers disagree
Two things to flag. First the amount: this page gives 0.5 to 1 mg a day, which is the figure published for this specific peptide. The generic family number of 1 to 2 mg gets applied to it by analogy and is up to twice as high. Second the route: one published protocol says subcutaneous in its introduction and intramuscular in its own dosing chart, on the same page. When a source cannot keep its own route straight, that tells you something about how firm the rest of it is.

How to mix a Prostamax vial

Follow one step at a time. The steps use the water amount from your calculator.

  1. Step 1: Check the label

    Find the mg printed on your vial and enter it in the calculator. Let a frozen vial reach room temperature first.

  2. Step 2: Wipe both stoppers

    Clean the top of the peptide vial and the water vial with an alcohol swab. Let them dry.

  3. Step 3: Measure 2 mL

    Draw bacteriostatic water with a sterile syringe.

  4. Step 4: Add it slowly

    Let the water run down the inside wall of the vial. This helps prevent foaming.

  5. Step 5: Swirl gently

    Roll the vial until the powder fully dissolves. Do not shake it hard.

  6. Step 6: Label and chill

    Write today's date on the vial and refrigerate it at 2–8 °C (35.6–46.4 °F), away from light.

What you need

A vial of powder, a vial of water, a 3 mL syringe, an insulin syringe, and alcohol swabs
  • Peptide vial
  • Bacteriostatic water
  • 3 mL syringe for adding water
  • U-100 insulin syringe for measuring
  • Alcohol swabs

Plan your supplies

Pick how many weeks you will run it and how many shots you take each week. The list below shows everything you need.

12weeks
Shots per week

Storage and warning signs

Powder vials

Store at −20 °C (−4 °F) in dry, dark conditions and keep them in the original packaging.

Mixed vials

Keep them refrigerated and away from light. How long a mixed vial lasts depends on the product, so check its stability data.

Stop using a vial if

  • The liquid turns cloudy.
  • You can see particles.
  • The seal is damaged.
  • You do not know its storage history.

Product info and what Prostamax is

Prostamax is a four amino acid peptide, Lys-Glu-Asp-Pro, written KEDP. It is the prostate peptide in the Russian bioregulator family.

Bioregulators come out of a different research tradition from most of the peptides on this site. The protocols are short courses repeated a few times a year rather than long continuous cycles, and most of the published work is Russian. That is worth knowing before you compare one with something like BPC-157, which is run very differently.

Type
Russian bioregulator tetrapeptide
Sequence
Lys-Glu-Asp-Pro (KEDP)
Associated tissue
The prostate
Common research vial
20 mg
Common water amount
2 mL, which makes 10 mg per mL
Amounts reported
500 to 1 mg a day
Course length
10 to 20 days
Repeat
Two to three times a year

What people use Prostamax for

Prostate tissue

The tissue the compound is associated with, and the reason people look it up.

Age-related prostate change

The Russian framing is about the tissue changing with age rather than about treating a diagnosed condition.

A short course model

A few weeks a year rather than a standing daily routine.

How fast people notice it

The cumulative model means this is not a peptide where you watch the first week. The protocol is built around repeating a short course over months.

What the research shows on Prostamax

The standard protocol

The protocol carried in the Russian literature for this family is a short daily course by subcutaneous injection, 10 to 20 days per cycle, followed by a real break before the next one. For this peptide the reported amount is 500 to 1 mg a day.

What it is

A tetrapeptide, KEDP, part of the Khavinson short peptide family.

The mix-up that matters most

A lot of the prostate clinical data attributed to Prostamax actually belongs to Prostatilen, which is a prostate tissue extract, a different preparation entirely. If you are weighing this up on the strength of clinical results, check which compound those results were in.

The animal work

Rat models of chronic aseptic prostatitis are what gets cited, with reports of less tissue swelling and less lymphoid infiltration. No randomized trial has looked at prostate outcomes with this peptide.

A naming caution

One review argues that what is sold under this name is a mixture of low molecular weight peptides rather than one characterized compound. If that is right, no specific mechanism can be pinned on it at all.

Where the evidence comes from

Most of the published work on this family comes from Vladimir Khavinson's group at the St Petersburg Institute of Bioregulation and Gerontology, or from researchers tied to it. There are no independent Western controlled trials.

Where to buy Prostamax

Laboratory research supplier

BioEdge Research Labs

Quality varies a lot between sellers. I have been around research peptides for 10 years, and BioEdge is the supplier I send my readers to. Here is why.

The Peptide Report has a business relationship with BioEdge Research Labs. BioEdge sells this product for laboratory research only. BioEdge shipping policy

Want to learn to do the math yourself? Open the practice tools ▾

Learn to work out any vial

Pick a tool and try it. Each one uses the numbers from your calculator.

Now try one yourself

Use the same four steps. Once you can solve these, you can work out the units for any vial you ever pick up.

Your score: 0 correct.

units

Learn to read the syringe

Each line on the syringe is a unit of liquid. A unit measures volume, so the amount of peptide in it depends on your mix.

Tap the syringe or move the slider. The numbers use the vial you entered above. Read the line at the top edge of the plunger.

10units
0.10mL
mcg in your mix

See what water changes

More water makes the mix weaker, so the same amount takes up more units. The amount of peptide in the vial stays the same.

A draw under 5 units is harder to read accurately. Tap a row to use that water amount.

Prostamax questions and answers

What is the Prostamax dosage?

The reported protocol is 500 to 1 mg a day by subcutaneous injection for 10 to 20 days, then a break before repeating two to three times a year.

How many units is 1 mg of Prostamax?

With a 20 mg vial and 2 mL of water, 1 mg is 10 units on a U-100 syringe and 500 mcg is 5 units. Use the calculator if your mix is different.

How long is a Prostamax course?

10 to 20 days. This is not a 12-week cycle.

How often can I repeat it?

Two to three times a year is what the protocol describes. The model is cumulative rather than continuous.

How good is the evidence here?

Thinner than the numbers make it look. Almost all of it comes from one research group, most of it is in Russian, and there are no independent controlled human trials.

How much water goes in a 20 mg vial?

2 mL is the usual choice, which makes 10 mg per mL and puts 1 mg at 10 units.

Why don't my units match another chart?

Most charts assume one vial size and one water amount. If your mix is different, every unit number changes, so run your own numbers.

This guide is for educational purposes only and is not medical advice. For research use only. Not for human or animal use. Reported amounts come from online sources and are not clinically validated. Consult a qualified healthcare professional for medical decisions.

Instant e-Book Download

Get Your Free Copy of The Ultimate Peptide Blueprint
Exact stacks, dosages & cutting-edge protocols to cut fat, build muscle, and keep results-no fluff.