The Peptide Report dosage guide

Melanotan 2 Dosage Guide and Calculator

Melanotan 2 research vial
Example vial shown

Melanotan 2 dosage chart and reported amounts

Reported use is 250 to 500 mcg of Melanotan 2 a day, over an initial 6 to 8 weeks. With a 10 mg vial mixed with 2 mL of water, 500 mcg is 10 units on a U-100 syringe and 250 mcg is 5 units. The human studies used a much larger amount, 0.025 mg per kg, which is about 1.75 mg at 70 kg. The mole and skin findings below are the part worth reading properly.

The amounts in this chart come from online communities. The vial label shows the total peptide in milligrams (mg). The Amount column shows a portion of that total in micrograms (mcg). The syringe mark shows how much liquid corresponds to that amount.

Syringe marks below are based on a 10 mg vial with 2 mL of water added. Change vial size or water in the calculator

ReportedAmountVolumeSyringe mark (U-100)Draws per vial
10 mg
mg
mL
Draw to this line
units on a U-100 syringe

Show me the math
1

Convert your vial to mcg, because 1 mg is the same as 1,000 mcg.

2

Divide by your water to see how much is in 1 mL.

3

Find what one unit holds. A U-100 syringe has 100 units in 1 mL.

4

Divide your amount by what one unit holds.

How people take Melanotan 2

How much
250 to 500 mcg a day is what gets reported. People tend to start small and work up.
How long
An initial 6 to 8 weeks is the figure carried forward.
The trial dose is much higher
The human studies used 0.025 mg per kg, which is about 1.75 mg at 70 kg and 2.25 mg at 90 kg. That is three to seven times the reported daily range. A visible tan appeared within about five doses in the first study.
Nasal sprays
The amount cannot be measured reliably. Every number on this page is for the vial.
Check your moles first
Not a throwaway line. The documented risk concentrates in people with many moles, a personal or family melanoma history, or sunbed use alongside it. This is the one to take seriously on this page.

How to mix a Melanotan 2 vial

Follow one step at a time. The steps use the water amount from your calculator.

  1. Step 1: Check the label

    Find the mg printed on your vial and enter it in the calculator. Let a frozen vial reach room temperature first.

  2. Step 2: Wipe both stoppers

    Clean the top of the peptide vial and the water vial with an alcohol swab. Let them dry.

  3. Step 3: Measure 2 mL

    Draw bacteriostatic water with a sterile syringe.

  4. Step 4: Add it slowly

    Let the water run down the inside wall of the vial. This helps prevent foaming.

  5. Step 5: Swirl gently

    Roll the vial until the powder fully dissolves. Do not shake it hard.

  6. Step 6: Label and chill

    Write today's date on the vial and refrigerate it at 2–8 °C (35.6–46.4 °F), away from light.

What you need

A vial of powder, a vial of water, a 3 mL syringe, an insulin syringe, and alcohol swabs
  • Peptide vial
  • Bacteriostatic water
  • 3 mL syringe for adding water
  • U-100 insulin syringe for measuring
  • Alcohol swabs

Plan your supplies

Pick how many weeks you will run it and how many shots you take each week. The list below shows everything you need.

12weeks
Shots per week

Storage and warning signs

Powder vials

Store at −20 °C (−4 °F) in dry, dark conditions and keep them in the original packaging.

Mixed vials

Keep them refrigerated and away from light. How long a mixed vial lasts depends on the product, so check its stability data.

Stop using a vial if

  • The liquid turns cloudy.
  • You can see particles.
  • The seal is damaged.
  • You do not know its storage history.

Product info and what Melanotan 2 is

Melanotan 2 is a synthetic ring-shaped seven amino acid peptide modelled on alpha-MSH, which is a 13 amino acid hormone. It was developed at the University of Arizona across the 1980s and 90s.

Its main target is MC1R, which drives pigmentation, but it also hits MC3R, MC4R and MC5R. That lack of selectivity is where its other effects come from, including the ones the first study did not go looking for. PT-141 was later developed out of it.

Type
Cyclic alpha-MSH analog, seven amino acids
Targets
MC1R, plus MC3R, MC4R and MC5R
Common research vial
10 mg
Common water amount
2 mL, which makes 5 mg per mL
Amounts reported
250 to 500 mcg a day
Trial dose
0.025 mg per kg, about 1.75 mg at 70 kg
Initial course
6 to 8 weeks

What people use Melanotan 2 for

Pigmentation

The main reason people use it, through MC1R.

Appetite

MC4R activity is why lower appetite turns up as a reported effect.

Sexual function

The 1998 and 2000 trials were erectile dysfunction trials, and PT-141 came out of that line of work.

What it does not do

Nothing establishes it as protection from UV damage.

How fast people notice it

A visible tan appeared within about five doses in the 1996 study.

What the research shows on Melanotan 2

The first human study

Dorr et al. 1996, Life Sciences, three healthy men. It started at 0.01 mg per kg daily and rose in small steps to 0.025 to 0.03 mg per kg. The authors picked 0.025 mg/kg for future trials. Spontaneous erections lasting one to five hours were a side effect in that study.

The erectile dysfunction trials

Wessells et al. 1998 in the Journal of Urology and 2000 in Urology, ten men each, both at 0.025 mg per kg. PT-141, bremelanotide, was later developed from this line.

The mole case reports

A 2017 review counted four melanoma cases tied in time to melanotan use, with causation unproven. The individual reports are specific: a 40 year old with a melanoma history and many atypical moles, a 25 year old sunbed user who developed more than 100 new moles after a four week course, and a 20 year old woman diagnosed with a buttock melanoma a few months after three to four weeks of use alongside sunbeds.

The rare serious events

Priapism in one case required drainage and an injection and had not recovered at four weeks. Rhabdomyolysis has been reported. A 45 year old lost blood supply to about half a kidney after roughly 27 mg over six months.

How often this comes up

Sweden's poison information centre logged 215 cases between 2008 and 2019. That is a real signal rather than a handful of anecdotes.

Mixing math

A 10 mg vial with 2 mL of water gives 5 mg per mL, so each unit holds 50 mcg and a 250 mcg dose is 5 units. That vial holds 40 such doses. With 1 mL instead, the same 250 mcg is 2.5 units.

Where to buy Melanotan 2

Laboratory research supplier

BioEdge Research Labs

Quality varies a lot between sellers. I have been around research peptides for 10 years, and BioEdge is the supplier I send my readers to. Here is why.

The Peptide Report has a business relationship with BioEdge Research Labs. BioEdge sells this product for laboratory research only. BioEdge shipping policy

Stacks to consider with Melanotan 2

The comparison people want is against the more selective tanning peptide.

StackIngredientsWhy people stack them
Melanotan 2 vs Melanotan 1Two vials, not run togetherMelanotan 2 in one vial. Melanotan 1 in the second.Same family, different compoundMelanotan 2 hits four melanocortin receptors, which is where the appetite and sexual effects come from. Melanotan 1 is more selective for MC1R and has the clinical trial record and an approved use behind it. See the Melanotan 1 dosage guide.
Want to learn to do the math yourself? Open the practice tools ▾

Learn to work out any vial

Pick a tool and try it. Each one uses the numbers from your calculator.

Now try one yourself

Use the same four steps. Once you can solve these, you can work out the units for any vial you ever pick up.

Your score: 0 correct.

units

Learn to read the syringe

Each line on the syringe is a unit of liquid. A unit measures volume, so the amount of peptide in it depends on your mix.

Tap the syringe or move the slider. The numbers use the vial you entered above. Read the line at the top edge of the plunger.

10units
0.10mL
mcg in your mix

See what water changes

More water makes the mix weaker, so the same amount takes up more units. The amount of peptide in the vial stays the same.

A draw under 5 units is harder to read accurately. Tap a row to use that water amount.

Melanotan 2 questions and answers

What is the Melanotan 2 dosage?

Reported use is 250 to 500 mcg a day over an initial 6 to 8 weeks. The human studies used 0.025 mg per kg, about 1.75 mg at 70 kg.

How many units is 250 mcg of Melanotan 2?

With a 10 mg vial and 2 mL of water, 250 mcg is 5 units on a U-100 syringe and 500 mcg is 10 units. With 1 mL instead, 250 mcg is 2.5 units. Use the calculator for your own mix.

How many doses in a vial?

A 10 mg vial holds 40 doses of 250 mcg, whatever water you add. Water changes the units per dose, not how much peptide is in the vial.

Does it protect my skin from the sun?

No. Nothing here establishes that. Darker skin and protected skin are different claims.

What about the melanoma reports?

Four cases have been tied in time to melanotan use in a published review, with causation unproven. The risk concentrates in people with many moles, a melanoma history, or sunbed use alongside it.

Why do I feel nauseous?

Nausea is the most common reported effect and it scales with the amount.

Are nasal sprays equivalent?

No. The amount cannot be measured reliably.

Why don't my units match another chart?

Most charts assume one vial size and one water amount. If your mix is different, every unit number changes, so run your own numbers.

This guide is for educational purposes only and is not medical advice. For research use only. Not for human or animal use. Reported amounts come from online sources and are not clinically validated. Consult a qualified healthcare professional for medical decisions.

Instant e-Book Download

Get Your Free Copy of The Ultimate Peptide Blueprint
Exact stacks, dosages & cutting-edge protocols to cut fat, build muscle, and keep results-no fluff.